GE CleanSpeak dryer error codes

GE CleanSpeak dryer error codes

GE

These error code explanations can help you diagnose a problem with your GE CleanSpeak dryer. For repair how-to help, visit the PartsDirect repair help section, which includes repair help for dryers, other major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more. Search for your model number to find a complete list of replacement parts for your dryer.

Error Code

Condition

DIY advice

F01 or F03

Inlet thermistor (temperature sensor) is defective

Check/Repair

The inlet thermistor is on the inlet duct at the back of the dryer. Unplug the dryer and measure the inlet thermistor resistance using a volt/ohm meter. If the resistance isn’t 47.6K to 52.4K ohms at 77 degrees F, replace the inlet thermistor.

How-to help

How to replace a dryer thermistor

Possible parts

Inlet thermistor

F02 or F04

Outlet thermistor shorted

Check/Repair

The outlet thermistor is on the blower housing at the front of the dryer. Unplug the dryer and measure the outlet thermistor resistance using a volt/ohm meter. If the resistance isn’t 98K to 102K ohms at 77 degrees F, replace the outlet thermistor.

How-to help

How to replace a dryer thermistor

Possible parts

Outlet thermistor

F05

Control board internal failure

Check/Repair

Unplug the dryer and replace the control board.

How-to help

How to replace a dryer electronic control board

Possible parts

Control board

F06

Stuck button

Check/Repair

Press all the buttons on the control panel to attempt to free the stuck key. If the key remains stuck, replace the control panel.

Possible parts

Control panel

F07

Power supply is miswired

Check/Repair

Unplug the dryer and properly wire the power cord according to the directions in the installation manual.

Possible parts

F08

Door switch stuck closed

Check/Repair

The door is not seen being opened after 5 consecutive completed cycles. The control expects to see the door opened after each completed cycle. If the control sees the door closed for 5 consecutive cycles, the control assumes that the door switch is defective. Unplug the dryer and reconnect any loose wires on the door switch. Replace the wire harness if damaged. If the wires are okay, replace the door switch.

How-to help

How to replace a dryer door switch

Possible parts

Door switch

F09

Long dry times

Check/Repair

Clean the lint filter. Clear the exhaust vent duct system of any clogs or restrictions. Unplug the dryer and reconnect any loose wires on the heating system. Replace any damaged heating system components.

How-to help

How to install a dryer gas valve coil kit

Possible parts

Heating system components

F010

Empty drum

Check/Repair

The controls detect that a cycle started and the dryer drum is empty. The code clears when you add garments to the drum and start a new cycle.

Possible parts

F011

Dry load

Check/Repair

The controls detect that a cycle started and the garments inside the drum are dry. The code clears when you add wet garments to the drum and start a new cycle.

Possible parts

Clipped from: https://www.searspartsdirect.com/diy/error-codes/dryer-repair/1234594/ge-cleanspeak-dryer/0432