Whirlpool Cabrio dryer error codes 2

Whirlpool Cabrio dryer error codes

Whirlpool

These error code explanations can help when troubleshooting a problem with your Whirlpool Cabrio dryer. For repair how-to help, visit the PartsDirect repair help section, which includes repair help for dryers, other major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more. Search for your model number to find a complete list of replacement parts for your dryer.

Error Code

Condition

DIY advice

AF

Exhaust air flow restriction

Check/Repair

The exhaust air flow to the outside of your home is restricted. Unplug the dryer and clear the exhaust air duct system going to the outside of your home.

Possible parts

PF

Power failure

Check/Repair

A power failure occurred while the dryer was running. Press Start to continue the cycle or press Stop to clear the display. If this code frequently appears, check the power cord and replace it if it’s damaged.

Possible parts

Power cord

F-01

Main electronic control board failure

Check/Repair

Unplug the dryer for 5 minutes and the plug the dryer back in. If the code reappears, replace the main electronic control board.

Possible parts

Main electronic control board

F-02

User interface keypad failure

Check/Repair

A stuck button on the user interface control board causes this code. If you can’t free the stuck key, replace the user interface control board.

Possible parts

User interface control board

F-22

Exhaust thermistor failure

Check/Repair

Unplug the dryer. Check the resistance of the exhaust thermistor (temperature sensor). It should measure about 10,000 ohms at room temperature. If the thermistor is defective, replace it.

Possible parts

Thermistor

F-23

Exhaust thermistor failure

Check/Repair

Unplug the dryer. Check the resistance of the exhaust thermistor. It should measure about 10,000 ohms at room temperature. If the thermistor is defective, replace it.

Possible parts

Thermistor

F-26

Drive motor failure

Check/Repair

Unplug the dryer. Check the wiring connections between the main electronic control board and the drive motor. If the wiring connections are sound, replace the drive motor.

Possible parts

Drive motor

F-28

Moisture sensor failure

Check/Repair

Check the wiring harness connections between the moisture sensor and the main electronic control board. If the wiring connections are sound, replace the moisture sensor.

Possible parts

Moisture sensor

F-29

Moisture sensor failure

Check/Repair

Check the wiring harness connections between the moisture sensor and the main electronic control board. If the wiring connections are sound, replace the moisture sensor.

Possible parts

Moisture sensor

F-31

Low L2 voltage

Check/Repair

The L2 leg of 240 volt power is below 30 volts. Check the house circuit breakers for the dryer and reset the L2 breaker if it’s tripped. Unplug the dryer and check the power cord wire connections on the terminal block. Reconnect any loose wires or replace the power cord if it’s damaged. Have an electrician check the 240 volt power supply for the dryer.

Possible parts

Power cord

F-47

Not used

Check/Repair

This error code may appear when entering diagnostics but you should ignore it because it isn’t used.

Possible parts

Clipped from: https://www.searspartsdirect.com/diy/error-codes/dryer-repair/1234594/whirlpool-cabrio-dryer/1198